Advanced Tuning

Preparation

Before continuing to the articles below, read and complete the following recommended actions to prepare the machine for advanced tuning:

• Sensor Dimensions - Verify the system dimensions are entered correctly for height sensor offsets and center rack width.

• Boom Angle Sensor - Ensure the automated calibration sequence is performed over flat ground. If the sensor dimensions were updated, re-perform the boom angle calibration.

• Hydraulic Oil - For best results, perform tuning with the hydraulic oil at normal operating temperature.

• Base Control Effort Calibration - Accurate base control effort values are necessary for successful advanced tuning. Only perform a Base Control Effort Calibration after warming the hydraulic oil. If possible, engage AutoBoom® XRT and drive slowly for two minutes prior to performing Base Control Effort calibration. This will ensure the Solenoid coils are at operating temperature and will give the most accurate Base Control Effort.

Last Revised: Jul 2024