Equipment Setup - Measurements Tab

  1. Select the Machine Panel icon in the bottom left corner of the Street Maps view to display the available machine configurations.

  2. Select any of the profile buttons for the machine or implements that are desired to be configured.

  3. Select the larger machine icon near the top of the screen. The General Information tab of the selected machine or implement will display.

    Note:  Use the page navigation at the bottom of the prompt, or swipe across the screen, to access other information for profiles assigned to the selected machine configuration.

  4. Select the Equipment tab to view the currently configured section group information. Refer to View Section Groups for information on the section group display or Modify Section Settings for assistance with creating a new section group.

  5. Select the Edit button in the desired section group to edit section group information.

  6. Select the Measurements tab to access the following settings for the selected section group:

Equipment Offsets

Use the following settings to configure the location of the section group on the machine or implement:

Select the left/right offset direction drop down and select the overall offset for the selected section group from the center-line of the machine or implement.

Select the offset distance field and enter the distance from the center-line of the machine or implement to the center of the section group in inches [centimeters]. The left/right offset distance must be measured perpendicular to the direction of travel.

Select the fore/aft offset direction drop down and select the position of the section group from the machine or implement pivot point.

Note:  The fore equipment offset may not be available when configuring some implement types.

Select the offset distance field and enter the distance from the pivot point to the section group in inches [centimeters]. The fore/aft offset distance must be measured parallel with the direction of travel.

Last Revised: Jul 2024