Create a Flip Area

A flip area is primarily used for planting and tilling to create a boundary around the edge of the field or another obstacle that creates a zone that will not be planted. This allows the user to plant the entire field and, when done with everything in the field except for the flip area, go back and plant that area last.

Configuring Flip Settings

  1. Select and hold the Flip widget on the run screen. The Flip Options window will open.

  2. Select either the Number of Swaths or Distance in: radial button.

  3. If Distance in: was selected, select the desired unit of measurement from the drop-down.

  4. Enter the desired amount (this will either be number or swaths or the desired distance.

Activating or Deactivating Flip

While running in a job:

  1. Press the left or right arrow to begin recording a Flip zone offset to that side.

  2. Press the arrow again to complete the Flip zone.

  3. Set to Activate to prevent applying in Flip zones.

  4. Set to Deactivate to allow applying in Flip Zones.

Last Revised: Jul 2024