Assemble and Mount the Tractor Roof Bracket

Assemble the Tractor Roof Bracket

  • Metric size 10 wrench and socket

  • Metric size 13 wrench and socket

  • Metric size 19 wrench

  1. Mount the device plate (Magnum P/N 107-2612-007) (Steiger P/N 107-2612-009) to the roof bar (Magnum P/N 107-2612-006) (Steiger P/N 107-2612-008) with the M8x16 bolts.

  2. Mount the RS Lite (P/N 063-0174-121) to the device plate using the M6x30 bolts with washers. The connector on the RS Lite will face forward.

  3. Install the RCU (P/N 063-2610-035) to the device plate using the M6x30 bolts with washers.

  4. Install the radio antenna (P/N 121-0000-052) on the right hand side of the roof bar.

    Note:  A 19 mm or adjustable wrench can be used to aid in the installation of the radio antenna.

  5. Install the radio cable (P/N 420-2002-108) to the RCU. Install the opposite end to the radio antenna.

Mount the Roof Bracket

warning

Use caution while working on the cab roof or standing on exterior surfaces. Surfaces may be uneven or slippery and hardware or harnesses may present tripping hazards. Contact a local equipment dealer for additional information or assistance with working on the roof or from an elevated position on a specific make and model machine.

  1. Make sure to stay off the tractor roof, damage can occur to the roof from excessive weight.

  2. Remove the rear cover from the CGR receiver to access the Port B connector.

  3. Connect the tractor Raven Cart Automation™ roof cable "CGR Port B" connector into port B on the CGR.

  4. Install the rear cover on the CGR receiver.

  5. Remove the two nuts from the cab roof studs.

    Note:  Secure the previously removed nuts with a tie strap to the roof bar.

  6. Loosely install the two rear standoffs (P/N 107-2610-033) to the cab roof studs.

    Note:  The word Rear is etched on the standoff.

  7. Mount the roof bar to the standoffs with M8x16 MM bolts.

    Note:  Tighten bolts on the tractor roof bar to a max torque of 4.97 Nm [44 in-lbs].

  8. Mount the front of the device plate to the CGR bracket. Install a M5 flat washer on a M5x50 MM bolt. Route the bolts through the device plate, spacer (P/N 104-1000-291), and CGR bracket. Secure the bolts with a serrated M5 flange lock nut.

    Note:  If a RTKClosed Real-time Kinematic antenna is mounted to the CGR it will need to be relocated to the roof bracket.

Last Revised: Jul 2024