Setup the AFS Vector Pro / PLM Cyngus Output to the RS Lite

1. Navigate to the GNSS Global Navigation Satellite System and Guidance setup screen under the UT A Universal Terminal (formerly Virtual Terminal) is an electronic display or console capable of interfacing with ECUs on an ISOBUS network. tab.

   

2. Add a new configuration and name it appropriately.

   

3. Turn off the ISO Can messages.

4. Set the port selection to ISO CAN BUS #2 and NMEA National Marine Electronics Association ISO Bus to OFF.

   

5. Select Receiver Serial Port #1.

   

6. Turn Terrain Compensation Off and turn the Port On. Set the Baud Rate to 115200.

   Note:  If the Baud Rate appears to be stuck at 38400, leave the setting at 115200 and reboot the system. After reboot verify the baud rate is set to 115200.

7. Set Precision to 8.

8. Set Port to ON.

   

9. Scroll down until the GGA and GSA setup buttons are visible.

   

10. Set the following settings:

    • GGA - 10Hz

    • GSA - .1Hz

11. Scroll down until the GST and RMC setup button are visible.

    

12. Set the following settings:

    • GST - 1Hz

    • RMC - Off

    • Scroll down the VTG and ZDA setup are visible.

    

13. Set the following settings:

    • VTG - .1Hz

    • ZDA - 1Hz

Turn off Guidance

1. Press the AccuGuide tab.

2. Set the AccuGuide Guidance to Off.

   Note:  Guidance will need to be turned on again if a user wants to return to factory guidance. Refer to Return the Tractor to Factory Guidance for more information.

   

Last Revised: Sep 2024